#Corel motion studio 3d diretx error driver
#Corel motion studio 3d diretx error manual

I just bought an easycap and it came with ulead video 8.0. (but it will still say ezcap on the unit) You have purchased an older, obsolete version. Why does it not come with Arcsoft software?ġ. I just bought an easycap and it came with ulead video. Below is some of the most popular 'easycap' questions we are asked. If you have just purchased a new easycap, You have bought a fake. Due to piracy, the company have changed their name from easycap to ezcap™. Then when the user upgrades to a newer version or full-version of Video Studio, the device no longer works. It gets very tricky.* Some special (SE**) versions of Video Studio have (apparently) been modified to work with a particular capture device. The driver, device, and capture software all have to be designed to work together. There seems to be no Microsoft standards for video capture drivers.

#Corel motion studio 3d diretx error driver

The driver (supplied by the hardware manufacturer) is the link between the device and the operating system & application. It's their responsibility to make sure all of these things work, and to make all of these things work together. I think it's the 'fault' of the Eaz圜ap manufacturer! They supplied the hardware, software, and driver. Since you're sending compressed data over the USB connection, the computer doesn't have to handle as much data and the 'system requirements' are usually minimal. With these USB gizomos the video compression is done in hardware. Which leads me to believe this is a problem with my computer, rather than the product?I wouldnt think so, but who knows?ĭoes the packaging/documentation say it works with WinXP ? Does your computer have a USB-2 port? (USB-1 is too slow for video). So I don't see why that is any reason for it to close. My computer is old and hasn't got very good specifications, however the system requirements for the Easycap and its editing software are lower than mine. I.e I've uninstalled/reinstalled it numerous times, updated DirectX, set the DEP to allow VideoStudio to run. I have viewed a couple of topics on here with similar problems and have followed the soloutions given.

#Corel motion studio 3d diretx error manual

The user manual says there should be the driver 'STK1160 ATV BDA,' however the disc I was given only installs 'SMI Grabber Device' However when I click capture, I am given a varying amount of time before it encounters an error and has to close (usually between 1 and 10 seconds) Does anyone have any solutions to that?īut also, when I open VideoStudio that came with the Eas圜ap 2.0, it's fine. So I set it all up, I have trouble installing the driver for it each time, every time I restart my computer it says its not working correctly so I have to re-install it. I recently bought an Eas圜ap 2.0 to record my gaming with, it literally arrived today.